7. Operation Instructions
7.1 Main menu
The tester is powered solely by the vehicle batte. Connect the Red (+) positive batte clamp
to the (+) positive batte terminal. And connect the Black (-) negative batte clamp to the (-)
negative batte terminal. Ensure that the clamp is securely attached to the correct terminals.
The display will show the page 1 below if all corrected. If not, you may get errors pages
(page 2) below, please double check the clamps and connection and have another t;
BT310 12V & 24V Batte Analyzer
4
OperationButtons
Increase the value / Page up
Decrease the value / Page down
Cancel / ReturnBack
Red Clamp
Black Clamp
ENTER Conrm / Enter / Proceed
Resta unit / Return under any status
Batte good condition light
Batte warning condition light
Batte bad condition light
Positive connection
Negative connection
To Next Page
Loading...