Vector MINI FRIDGE COOLER AND WARMER User Manual

8
OBSERVE ALL CAUTIONS AND WARNINGS.
CARE AND MAINTENANCE
The Mini Fridge
™
Cooler and Warmer is ruggedly constructed to provide
years of dependable service.
- After each use, clean the unit, inside and out, with a soft cloth and mild
soap solution.
- Do not scrape, scratch or puncture the surface of the unit with sharp objects
or abrasives.
- Dry the unit properly and store in a cool, dry place.
- Always make sure the power cord and converter are disconnected before
storing.
- Never allow the unit to be immersed in liquid.
TROUBLESHOOTING:
Problem/Possible Cause/Remedy
• Mini Fridge
™
Cooler and Warmer is not functioning as cooler or warmer
(fan is not turning)
• Accessory outlet of DC power supply is not functioning-check by plugging
in a 12VDC appliance. If not, clean accessory outlet and reconnect the
Mini Fridge
™
Cooler and Warmer .
• Fuse or circuit breaker in accessory outlet is open. Reset breaker or check fuse, and
replace fuse if necessary. (See paragraph below)
• Ignition is switched off - start engine or switch ignition to “accessory” position.
• Fuse in unit’s DC power plug is blown - see Fuse Replacement section for location of
fuse and instructions for checking and replacing fuse.
- Refrigerator/warmer is not cooling or heating properly (fan is not turning).
• Fan is defective. Call Vector Customer Service Department for return/replacement
instructions. This unit is not user-serviceable, it must be returned to Vector
Manufacturing for professional service or repair. Any attempt to service by user will
void warranty.
- Refrigerator/warmer is not cooling or heating, but fan is turning
• Cooling unit is defective. Call Vector Customer Service Department for
return/replacement instructions. This unit is not user-serviceable, it must be returned
to Vector Manufacturing for professional service or repair. Any attempt to service by
user will void warranty
- Refrigerator/warmer takes longer than 2 hours to reach desired temperature inside
• Low battery or supply voltage. Check converter output
• Unit will attain desired temperature more efficiently if items are pre-heated
or pre-chilled
• Fan area is blocked - Move unit or object

Vector MINI FRIDGE COOLER AND WARMER Specifications

Power

operating voltage	12 volt DC
ac/dc power adapter	110/120 volt AC to 12 volt DC at 4 amps
amperage draw	3.6 amperes
power cord length	7 feet
fuse rating	10 amp

Performance

cooling performance	Cools to average 40ºF below ambient temperature
warming performance	Warms to 60°F above surrounding air or 120°F maximum
cold/heat transfer	Temperature-efficient, aluminum-coated liner

Weight and Dimensions

inside width	5.8 inches
inside depth	5.5 inches
inside height	9.85 inches
outside width	8 inches
outside depth	7.25 inches
outside height	14 inches
weight	5.2 lbs (2.36 Kg)