Vector MINI FRIDGE COOLER AND WARMER User Manual

9
FUSE REPLACEMENT
The power cord is fuse-protected against short-circuiting, by a 10-amp fuse
located in the tip of the cigarette lighter plug. If the DC socket is powered, but the unit
does not operate, then the cooler/warmer fuse may be open.
To inspect or replace the DC Power Cord Fuse
1. Unscrew the end-cap of the DC plug counterclockwise.
2. Remove fuse, inspect it for an open element, and replace with a new 10 amp fuse,
if needed.
3. Re-attach the end-cap to the plug.
4. If new fuse opens, call Vector Customer Service Department for further instructions
and possible return/replacement. This unit is not user-serviceable, it must be
returned to Vector Manufacturing for professional service or repair. Any attempt to
service by user will void warranty.
SPECIFICATIONS:
Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8 cans /1.25 gallons (US)
Operating Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 volt DC
Power Cord: . . . . . . . . . . . . . .7', with 10 amp fuse protected 12v DC plug
AC/DC Power Adapter: . . . . . .110/120 volt AC to 12 volt DC at 4 amps.
Amperage draw: . . . . . . . . . . . . . . . . . . . .3.6 amperes (approx. 44 watts)
Cooling Performance: . . .Cools to average 40ºF below ambient temperature
Warming Performance: . . . . . . . . . . . . .Warms to 60°F above surrounding
air or 120°F maximum
Cold/Heat Transfer: . . . . . . . . .Temperature-efficient, aluminum-coated liner
Insulation: . . . . . . . . . . . . . . . . . . . . . . . . . . . .CFC-free polyurethane liner
Heat Dissipation: . . . . . . . . . . . . Built-in fan with long-life, brushless motor
Warm/Cool System: . . . . . . . . . . . . . . . . . . . .Non-wearing thermoelectric
Inside Dimensions . . . . . . . . . . . . . . . . . . . . . . . .5.8”W x 5.5”D x 9.85”H
Outside Dimensions . . . . . . . . . . . . . . . . . . . . . . . .8”W x 7.25”D x 14”H
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5.2 lbs (2.36 Kg.)

Vector MINI FRIDGE COOLER AND WARMER Specifications

Power

operating voltage	12 volt DC
ac/dc power adapter	110/120 volt AC to 12 volt DC at 4 amps
amperage draw	3.6 amperes
power cord length	7 feet
fuse rating	10 amp

Performance

cooling performance	Cools to average 40ºF below ambient temperature
warming performance	Warms to 60°F above surrounding air or 120°F maximum
cold/heat transfer	Temperature-efficient, aluminum-coated liner

Weight and Dimensions

inside width	5.8 inches
inside depth	5.5 inches
inside height	9.85 inches
outside width	8 inches
outside depth	7.25 inches
outside height	14 inches
weight	5.2 lbs (2.36 Kg)