5. EMERGENCY/WORK LIGHT
Bulb Replacement
You will need a small Phillips screwdriver
1. Replacement bulbs are available from Vector® Customer Service Department; call (954) 584-4446 EXT. 19 or toll-free (866) 584-
5504
2. Remove two Phillips screws from the lens.
3. Lift off the lens assembly.
4. Remove the burned-out bulb.
5. Replace with a new bulb (12-volt 0.4 amp Krypton bulb).
6. Snap the lens cover back into place, and replace Phillips screws.
6. BATTERY REPLACEMENT
IT IS RECOMMENDED THAT THE UNIT BE RETURNED TO VECTOR® CUSTOMER SERVICE FOR BATTERY
REPLACEMENT: CONTACT (954) 584-4446 EXT. 19, OR TOLL-FREE (866) 584-5504
6.1 Battery Disposal
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly. Some states require recycling
— contact your local authority for information.
THIS UNIT CONTAINS A MAINTENANCE-FREE, SEALED, NON-SPILLABLE, LEAD ACID BATTERY
WHICH MUST BE DISPOSED OF PROPERLY. SOME STATES REQUIRE RECYCLING. DISPOSAL QUESTIONS? IN USA,
CALL 1 -877-288-7722.
WARNINGS:
. DO NOT DISPOSE OF THE BATTERY IN FIRE AS THIS MAY RESULT IN AN EXPLOSION.
. BEFORE DISPOSING OF THE BATTERY, PROTECT EXPOSED TERMINALS WITH HEAVY-DUTY
ELECTRICAL TAPE TO PREVENT SHORTING (SHORTING CAN RESULT IN INJURY OR FIRE).
. DO NOT EXPOSE BATTERY TO FIRE OR INTENSE HEAT AS IT MAY EXPLODE.
7. SPECIFICATIONS
Model VECO21 ST
Voltage 12 VDC
Boost Power 400 Instantaneous Cranking Amps
Peak Ampere Power 1200 Amps
Battery Type Non Spillable Sealed, lead- acid, rechargeable,
maintenance-free, 12-volt DC,19 Amp-hour
Bulb 12-volt 0.4 Amp Krypton
Booster Cables #5AWG welding cable
with 400 Amp copper clamps
Accessory Socket Self-Resetting Breaker 20 Amps
Charging Cord 12-Volt DC
Adapter/Charger 110/120-Volt AC
(800mA, 12-Volt DC Output)
HEIGHT 11-3/4” (29.845CM)
DEPTH 6-1/4” (15.875CM)
WIDTH 11-5/8” (29.528CM)
WEIGHT 18LBS. (8.164KG)
To Next Page
Loading...
Need help?
General
