To Next PageTo Next PageWhat to do if my Vector VEC024 Inverter has no AC output and the red LED is lit?
If your Vector Inverter shows no AC output and the red LED is illuminated, it could be due to the DC input being below 10 volts or an excessive appliance load causing a thermal shutdown. In the first case, recharge or replace the battery. In the second case, reduce the load and allow the inverter to cool down before turning it off.
Why does my Vector Inverter's low battery alarm sound continuously?
A continuous low battery alarm on your Vector Inverter usually indicates a bad connection or wiring issue. To resolve this, tighten all DC connections.
What to do if my Vector VEC024 Inverter's low battery alarm sounds?
If the low battery alarm is sounding on your Vector Inverter, it likely means the battery voltage is low. You should recharge the battery and remove the load from the inverter while it's recharging.
Why isn't my motorized power tool operating at the correct speed with my Vector Inverter?
If a motorized power tool isn't operating at the correct speed when used with your Vector Inverter, it may be due to a purely inductive load. To correct this, make the load not purely inductive by operating an incandescent lamp at the same time as the motor.
How to eliminate TV/radio interference with Vector VEC024?
To reduce snow in the picture or buzzing in the speaker when using a television or radio with your Vector Inverter: * Keep the inverter and antenna distant from each other. * Use shielded antenna cable. * Connect the antenna to an amplifier.
Why won't my motorized power tool start with my Vector VEC024 Inverter?
General| Input Voltage | 12V DC |
|---|---|
| Output Voltage | 120V AC |
| Waveform | Modified Sine Wave |
| Weight | 0.7 kg |
| Dimensions | 150 x 80 x 40 mm |
| Efficiency | Up to 90% |
Critical warnings to prevent fire, electric shock, explosion, or injury during operation.
Advises against conditions and practices that may damage the inverter or cause personal injury.
Explains the two-stage DC-to-DC conversion process of the inverter from input to output.
Guides on connecting the inverter to the DC power source using plug or provided cables.
Covers low battery, over voltage, and short circuit protections with their parameters.
Details overload, over temperature, and low battery alarm functions.
