Page 2
Key Functions
Press to silence the alarm. This will
not reset the display or disable any
alarm functions.
Press to generate the various
reports.
The period (.) is on key "1". The decimal point (•)
is on the Right Arrow key (➨).
Contractor plugs ID Key into TLS and
presses the blue key to log in for a
work session.
Press to change to a different
option than currently displayed.
Select a character by successive presses of the
key. Press once for "A". Press again for "B",
again for "C" and a fourth time to enter a "2".
Press to select the system mode:
Operating Mode, Setup Mode, Diag-
nostic Mode.
Press to move to the next proce-
dure within each function.
The zero key has a space (❑), a hyphen (–) and
the comma (,).
Press white key to print out the Main-
tenance Report if Maintenance His-
tory or Tracker is enabled.
Press to advance the paper
through the printer.
The Arrow keys are used to move the cursor left
and right (as with this example) without chang-
ing the displayed character.
Used to move back through Steps,
Functions and Modes.
Press to select an option. Also to
start leak tests.
Press to select the various Functions
within each Mode.
Press to change to the next tank
or sensor.
ALARM
TEST
PRINT
1
Q Z
CHANGE
2
A B C
MODE
STEP
0
PAPER
FEED
•
BACKUP
ENTER
FUNC-
TION
TANK
SENSOR
To Next Page
Loading...