P.8
TROUBLE SHOOTING
NO SOUND
- Ensure the AC/DC adaptor is fully inserted into the AC outlet and the
power connection input on the transmitter.
- Ensure the speakers are switch ON.
- Speaker’s battery capacity is too low, replace with new batteries or
connect the AC/DC adaptors to the speakers.
- Ensure the TV or audio component is ON.
- The connected audio / video equipment is not playing. Start playing the
equipment.
- The volume of speakers is too low, adjust the volume to an appropriate
level.
DISTORTED
- Press the “AUTO-TUNE” button on the speakers until matching the
frequency of the transmitter.
- Change the position of the channel selector on the transmitter. You must
then press the “AUTO TUNE” button on the speakers.
- Battery capacity is too low. Replace with the new battery.
- Ensure the volume level of speakers is adjusted properly.
- The speakers are too far away from the transmitter, move it closer.
- The input level of the audio signal is too low. Turn up the volume of the
audio source equipment.
P.9
TECHNICAL SPECIFICATIONS
Transmission Mode : UHF
Carrier Frequency : 863 MHz Digital Hybrid
Operation Voltage : Transmitter, DC 12.5V 150mA
Speakers, 6 X ‘C
9V 1.5A adaptor
Remote Control Unit, 2 X ‘AAA’ size batteries
Frequency Response : 40Hz – 12KHz
Distortion : 1%
S/N Ratio : 65dB (typical)
Operation Distance : Up to 100 meters
Speakers : 2-way
Output Power : 2 x 5 Watts
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
To Previous Page
Loading...
Need help?
Transmission
Power
Audio
Performance