Veho SMARTFIX VFS-014-SF - Whats in the Box; Scanner Controls and Setup; Installing and Charging the Battery; Status LED Indicators

4 5
3. Put a slide/negave into the holder as shown.
4. Close the holder, making sure that the tray closes correctly.
6. Using the VFS-014-FS
1. Insert an SD card into the scanner, following the illustraon on the rear of the scanner.
3. Installing and charging the baery
1. Insert the baery into the base of the scanner.
2. Connect the Mini-B USB cable to the rear of the scanner, then plug the other end of the
USB cable into a USB port on a computer or 5V/1A AC Adaptor.
3. When charging, a red LED will light up. When the baery is fully charged, the red LED
will turn o.
4. Status LED
Red The Veho Scanner is turned o and the baery is charging.
Purple The Veho Scanner is turned on and the baery is charging.
Blue The Veho Scanner is turned on.
5. Inserng Slides or Negaves into the holder
1. Place the holder so the glossy side faces up.
2. Open the holder as illustrated.
EnglishEnglish