Veho SMARTFIX VFS-014-SF - Image Playback and Management Features; Accessing and Navigating Playback Mode; Slideshows and Image Deletion; Formatting SD Card and TV Output

8 9
Please note: To save power, the Veho Scanner will go to sleep mode aer 3 minutes of being
inacve. You can come out of sleep mode by pressing any buon on the scanner.
If the Veho Scanner is inacve for 6 minutes, it will turn o automacally.
7. Playback mode
1. You can use Playback mode to view the images that you have scanned onto the SD card.
2. Press the Playback buon to enter playback mode:
3. Press the Up or Down buon to change the selected image.
4. Press the playback buon again to enter slideshow mode.
5. Press the Playback buon again to go back to scanning mode.
8. Deleng images
1. Enter Playback mode, then select the image you want to delete.
2. Press the Delete buon once, then Okay to delete the selected image.
3. Press the Delete buon twice, then Okay to delete all images.
4. Press the Delete buon three mes then press the Okay buon to format the SD card.
Please note: formang the SD card will remove all les from the SD card, not just the images
saved by the scanner.
9. Connecng the scanner to a computer.
1. Plug the USB cable into the rear of the scanner and to a USB port on the computer.
2. Press the Power buon to turn the scanner on.
3. Use the Up or Down buon to select Yes or No and press Okay.
4. Select Yes to view the les on your computer, the SD card will appear as a removable disc
in “My Computer” or “This PC” for Windows users or on your desktop for Macintosh users.
5. Select No to use the scanner to scan slides/negaves while charging from a USB port.
10. Viewing images on a TV
The scanner is compable with Mac and Windows operang systems, allowing you to copy the
les directly from the SD card in the scanner without using a USB card reader. There is no
soware included or required to use the scanner on either operang system.
1. Set the TV to the correct input, and then connect the scanner to the TV using the 3.5mm
jack to yellow RCA cable.
2. Turn the scanner on.
3. Press the Playback buon.
4. Use the Up or Down buon then the Okay buon to select PAL or NTSC to match your region.
5. Press the Up or Down buon to change the selected image.
6. Press the Playback buon again to start a slideshow. You can use the Up or Down buon
to pause a slideshow, then press the Playback buon to resume the slideshow.
11. Safety informaon and specicaons
Specicaons
Image Sensor 1/2.33" 14 Mega CMOS Sensor,
Preview and Review 2.4" Color LCD Display
Lens Specicaon F=4.8, f=12.95mm
Color Balance Automac
Exposure Control Automac & Manual adjustment
EnglishEnglish