Need help?Do you have a question about the Veichi AC70-T3-5R5G/7R5P and is the answer not in the manual?
General| Model | AC70-T3-5R5G/7R5P |
|---|---|
| Category | Inverter |
| Control Mode | V/F control, vector control |
| Cooling Method | Forced air cooling |
| Power | 5.5kW |
| Input Voltage | Three-phase 380V |
| Output Power | 5.5kW |
| Output Current | 11A |
| Frequency Range | 0-400Hz |
| Protection Features | Over-current, over-voltage, under-voltage, over-heat, overload, short circuit |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20℃~+60℃ |
| Humidity | 5%~95%, without condensation |
| Altitude | ≤1000m |
Important safety requirements and cautions before using the inverter.
Provides safety regulations and warning signs for secure operation and to prevent damage.
Crucial safety precautions for installation and wiring to ensure safe and stable operation.
Covers essential electrical installation procedures and safety precautions.
Lists critical safety precautions for electrical installation.
Crucial safety precautions for basic operation and trial runs.
Explains the appearance, key functions, and indicator light meanings of the inverter's keyboard.
Covers fundamental operation procedures of the inverter.
Details the process of setting parameters using the keypad.
Guide for performing a trial run and commissioning the inverter.
Instructions for selecting and performing motor parameter auto-tuning.
Categorizes different types of faults and inverter actions during faults.
Detailed explanation of fault codes, possible causes, and treatments.
Systematic processes for diagnosing system, over-current, over-voltage, voltage, and overload faults.
Essential safety rules to follow during overhaul and maintenance activities.
Procedures and recommendations for periodic overhaul and component checks.
Critical safety rules for using peripheral equipment and options.
Lists and describes common peripheral equipment for the AC70 inverter.
Lists and explains fundamental parameters like control method and running command selection.
Covers control methods, command channels, frequency references, and limit settings.
Defines parameters related to external terminal connections and functions.
Details special function parameters for advanced configuration.
Covers PID output characteristics, signal sources, preset values, and tuning parameters.
Section detailing fault diagnosis and display.
To Next Page