Device Installation
Close the water supply line prior to installation. Electrical current
should be interrupted in the electricity connection cable. Remove or
shut-off fuses.
Legal instructions, electricity and water distribution organization’s
connection terms and features and technical values given on the label
located on the device should be followed.
Installation Place:
Above given image should be taken into consideration for correct
placement of the device.
Approximately 60 mm free space should be available at all sides around
the device for installation.
Device should be installed vertically at a place not to directly contact with
the water.
The distance between the device and the tap should be as short as
possible to prevent heat losses.
To Next Page
Loading...
