Connect cold line of the device
(marked with outer arrow) to water
inlet tap, and hot water line (marked
with inner arrow) to water outlet
sleeve.
During the connection, use one
each 1/2" sealing gaskets on each end and perform the tightening with a
suitable wrench. Control correctness of connection directions with arrows.
Arrows should be outwards at water inlet direction, and inwards at water
outlet direction (same direction with the water flow).
Device water inlet pipe has elastic steel connection and can be easily
shaped with hands depending on installation conditions. Water outlet pipe
is made of soft copper and may be shaped manually or with a plier without
damaging the pipe depending on installation conditions.
Open the water valve to supply water to device and taps and control any
possible leaks in connections. Then, open and close the hot water tap for
several times to clean the system and device from air gaps those may occur.
Deflating the instant water heater: Completely open the hot water tap and
rinse the device for 1 minute until no bubbles come out for this.
Electrical Connection (Only by an Authorized Technician):
Attention Please!
Electrical connection should be performed depending on applicable national
regulations or local regulations defined by the local electricity distribution
company. Instant water heater is a device with Protection Class I and must
be connected with an earthed cable! All water connections should be
completed before applying electrical connections!
To Next Page
Loading...
