Usage (BLUE S)
Outlet water temperature can be adjusted between 20°C and 60°C by
rotating the temperature set button located on device front cover. Adjusted
temperature value is controlled at the LCD screen. When the hot water tap
is opened and stable water flow is maintained, device automatically starts
operation and heats the water until the adjusted value.
Device operation can be monitored via the instant power indicator located
on the LCD screen. Device adjusts the requested power amount
automatically depending on the requested outlet water temperature and the
amount of power consumed (between 10% and 100%) can be monitored
from the device LCD screen. "eco" indicator located just beneath the instant
power indicator remains lit when the amount of power consumed is less
than 60%. "eco" indicator means that the device realizes the heating
operation economically depending on the power consumed instantly. "eco"
indicator dims out at 60% and higher instant power values and this situation
indicates that the device performs heating by consuming more power. Pay
attention that requested water temperature and water amount is not more
than required to economically use the device.
Water temperature value indicated on the screen means the temperature
seen within the device. Temperature of water coming out from taps intended
for use varies due to heat losses in pipes located at the installation and may
be lower than requested.
Using With Solar Power Systems
Three phase electronic instant water heaters may be operated with solar
power systems. If device inlet water temperature exceeds 30°C, the sun
image lits on the LCD screen (BLUE S) or the status LED located on the
electronic card starts flashing (BLUE). This situation indicates that
previously heated water enters into the device and device consumes power
adequate for the requested temperature value. The point required to be
taken into consideration during use with solar power systems is that the
inlet water temperature should not exceed 55°C.
To Next Page
Loading...
