88
89
Owner’s Manual
To activate the Velec electric motor of your bicycle :
1. Press the -/O on the right side of the battery
2. Press the -/O on the LCD Panel
1. –/O
button on Battery
2. –/O
button on Control Panel
S SERIES KIT 36V
The Control Panel has 4 indica-
tors, red lights that indicate the
battery’s charge level: 4 lights on
indicate the battery is about 100%
full. 3 red lights mean the battery
is about 70% charged. 2 lights
mean approximately 40% charge
and 1 red light means the battery
charge is approximately 10%.
Control Panel’s
–/O (on/off) Switch
Battery
You may turn the motor On and Off by pressing the –/O switch on the
Control Panel. To turn the electrical power OFF entirely, simply press the -/O
on the right side of the battery.
Battery Charge Indicator
on Control Panel
36V
Use this mode whenever you wish to benefit from electrical assistance,
which makes pedalling easier.
(This mode gives you longer range for the same charge.)
ASSISTANCE MODE
NO-PEDALLING MODE
From a stop or while in motion, simply turn the Throttle Handle (on the
right) to move forward. To reach the top of some of the hills, it is possible
you might have to pedal as well.
Based on ideal conditions with a fully-charged battery .
The range will be reduced depending on the type of roadway, the number
of slopes and the degrees of inclination, the direction and the force of wind,
the tire pressure, the weight of the bicycle and the user.
To Next Page
Loading...
Need help?
General
