16
Test procedure
The included demo software makes it easy to experiment.
Start by selecting the address : tick off SK5 and/or SK6 (see address selection).
ATTENTION : Execute these settings before connecting the kit with the computer or before booting the computer.
Connect the USB cable.
LED LD3 'Power' lights up if the connection has been executed properly.
After startup LD8 (output 8) will flash momentarily to indicate that the circuit works as it should.
Start the program 'K8055_Demo.exe'.
! Next press the 'connect' button to connect the K8055 with the computer.
21 Test procedure
SK5 SK6 ADDRESS
ON ON 0
OFF ON 1
ON OFF 2
OFF OFF 3
To Next Page
Loading...
