Vello WIRELESS SHUTTRBOSS 4.0 User Manual

22
LONG: Exposure Time
LONG sets the exposure time
for each shot. This can be
much longer than the camera’s
available shutter speeds. You
can select exposure times
from 1 second to 99 hours 59
minutes and 59.9 seconds. The
confirmation LED will turn solid
red during a long exposure.
Note: For exposures 1 second and
longer, set your camera to Bulb
mode, and then set the exposure
time on the ShutterBoss. Use the
camera to control exposure times
faster than 1 second.
1. Set your camera’s exposure
mode to Bulb.
2. Press the / arrows to
position the cursor beneath
LONG.
3. Press the Set button to
change the exposure time
settings. The time increments
will blink.
4. Use the / arrows to
move between hours,
minutes, seconds, and tenths
of a second.
5. Use the / arrows to
change the time increments.
6. Press Set to confirm.
7. Press the button to begin
the timer.

Vello WIRELESS SHUTTRBOSS 4.0 Specifications

General

Self-Timer Delay	0 sec. to 99 hr. 59 min. 59.9 sec.
Exposure Time	1 sec. to 99 hr. 59 min. 59.9 sec.
Interval Time	1 sec. to 99 hr. 59 min. 59.9 sec.
Number of Shots	1 to 199, infniite
Wireless Range	196 ft. (60 m)
Power Source	Transmitter: 2 × AAA batteries (not included) Receiver: 2 × AAA batteries (not included)
Standby Time	48 hr.
Operating Temperature	14°F to 113°F (−10°C to 45°C)
Storage Temperature	14°F to 140°F (−10°C to 60°C)
Dimensions (H × W × D)	Transmitter: 5.1 × 1.8 × 0.8 in. (130 × 46 × 21 mm) Receiver: 3.3 × 1.5 × 1.2 in. (85 × 37 × 31 mm)

Weight and Dimensions

Weight	Transmitter: 2 oz. (56.5 g) without batteries Receiver: 1.4 oz. (40 g) without batteries