Vemer CHRONOS Series - Page 53

&OHMJTI
- 15 -
CHRONOS Programmable Thermostat User Manual
3. The value of the flashing T1 temperature is
EJTQMBZFE.PEJGZUIFWBMVFXJUIUIFLFZT
and and press the key to move
to the modification of T2.
4. The value of the flashing T2 temperature is
EJTQMBZFE.PEJGZUIFWBMVFXJUIUIFLFZT
and and press the key to move
to the modification ofi T3.
5. The value of the flashing T3 temperature is
EJTQMBZFE.PEJGZUIFWBMVFXJUIUIFLFZT
and and press the key to go
back to the page of T1 temperature.
6. Once all parameters are set, to exit and to
go back to the programming menu, press
for a short time the key
.
To exit and to go back to the normal
operation press for a long time the key
PSXBJUGPSUIFUJNFPVUFYQJSBUJPO
seconds about).
"UUFOUJPOUIFWBMVFTPGTFUUFNQFSBUVSFT
NVTUSFTQFDUUIFDPOEJUJPO
5õ5õ5
In cooling mode T1 is not
TFUUBCMFBOEFRVBMTPGGTZTUFN