3 6 0 5 • 3 60 6 13 4225 1 3 3 R e v C
DUAL PINION GEAR
The dual-spiral configuration utilizes a single motor and a pair of pinion gears, the motor pinion gear drives the idle paired gear.
The idle pinion gear/spiral adaptor is snapped into its retainer and held in place by the housing as shown below.
The pairs of gears/spirals are staggered across the tray, each pair being either in front or behind the adjacent pair. The pinion gear
can be installed with a smaller or larger spacing from the back of the tray by flipping it around 180°. This ensures that the pairs of
pinion gears do not engage with each other, see below:
To Next Page
Loading...
