What to do if air is too cold from Venmar AVS Fan?
If the air feels too cold at the air supply grille of your Venmar AVS Fan, consider the following: * Check that the stale air exhaust hood outside the house is not blocked. * Operate the unit at low speed or in intermittent mode. * Have the system's balancing checked. * Have the unit's defrosting system checked. * Consider installing a duct heater.
How to fix air that is too dry with Venmar AVS CONSTRUCTO 1.5 Fan?
If the air feels too dry when using your Venmar AVS Fan, here are a few things to try: * Do not adjust your humidity control below -20°C (-4°F). * Operate the unit at low speed or in intermittent mode. * You can also temporarily use a humidifier.
What does blinking red LED mean on Venmar AVS Fan?
If the LED on the integrated control of your Venmar AVS Fan is blinking red, it indicates a problem with the motor. Contact your installer for assistance.
Why is the LED blinking amber on my Venmar AVS Fan?
If the LED on the integrated control of your Venmar AVS Fan is blinking amber, it indicates a problem with the motorized damper. Contact your installer.
What does a blinking green LED mean on Venmar AVS CONSTRUCTO 1.5?
If the LED on the integrated control of your Venmar AVS Fan is blinking green, it indicates a problem with the thermistor. Contact your installer.
How to troubleshoot a Venmar AVS Fan that isn't working?
If your Venmar AVS Fan isn't working at all, check if the unit is properly plugged in and ensure that the breaker is receiving power from the house circuit breaker.
Explains symbols used in the guide for warnings, cautions, and notes.
Details physical dimensions, weight, electrical supply, and power consumption.
Explains how the unit transfers heat between indoor exhaust and outdoor fresh air.
Describes the unit's automatic defrost cycle for cold weather conditions.
Details the function of the integrated control button and LED indicator for unit operation.
Covers convenience controls like Lite-Touch and other main wall units.
Guides on selecting fan speed and setting humidity levels for comfort.
Control to eliminate excess humidity from specific areas.
Button to activate high-speed ventilation for 20 minutes.
Timer for activating high-speed operation for periods up to 60 minutes.
Covers cleaning air filters, heat recovery core, and intake hood.
Annual service including cleaning filters, core, blowers, and condensation tray.
General| Fan type | Centrifugal |
|---|---|
| Motor type | PSC |
| Voltage | 120 V |
| Power consumption | 150 W |
| Airflow | 150 CFM |
| Mounting Type | Ceiling |
| Duct Size | 6 inches |
To Next Page