Venmar AVS CONSTRUCTO 1.5 - Optional Auxiliary Controls; Dehumidistat Operation; 20-Minute Lighted Push Button; 60-Minute Crank Timer

3.0 CONTROLS (CONT’D)
3.3 OPTIONAL AUXILIARY CONTROLS
Location: Located in the bathroom or in other locations where there is temporary humidity
excess.
Purpose: To eliminate excess humidity produced by showers or other periodic activities
producing humidity.
In the fall, winter and spring:
Adjust knob to the desired humidity level.
In summer:
Set knob to the SUMMER position.
VC0083
CAUTION
Do not select a humidity level below 30%. This could lead to excessive dryness
in the air causing discomfort for the occupants.
Location: Located in the bathroom or in other locations where there is temporary humidity excess
or pollutants.
Purpose: To eliminate excess humidity produced by showers or other periodic activities
producing pollutants.
Press once to activate the push-button. The unit will operate on high speed for 20 minutes and the
indicator will light up. To stop activation before the end of the 20-minute cycle, push one more time.
The unit will get back to its previous setting.
VC0082
ON
Location: Located in the bathroom or in other locations where there is temporary humidity excess
or pollutants.
Purpose: To eliminate excess humidity produced by showers or other periodic activities
producing pollutants.
This control makes the system operate at high speed for periods varying from 10 to 60 minutes.
OFF
10
20
30
40
50
60
TURN
PAS T
20
VC0017
3.3.1 Dehumidistat
3.3.2 20-Minute Lighted Push Button
3.3.3 60-Minute Crank timer
6