Ⅰ
Ⅳ. Operating procedures
1. Switch on the power lock;
2. Press the forward and backward rocker switch, lock it in forward or
backward state, and check whether it is in place;
3. Release the parking brake;
4. Press the accelerator pedal at a constant speed and the vehicle starts.
When opening the power lock, the forward and backward switch must
be in neutral position, otherwise the vehicle will not be driven; if you step on
the accelerator pedal first and then open the power lock, the vehicle
will not
be driven. A
t this time, you must release the pedal and then step on the pedal
again before the vehicle is driven.
Ⅴ. Codes of safety practice
The driver must fully understand the technical performance, control
mechanism and operating procedures of the vehicle, and abide by the following
codes of safety practice:
The vehicle is off-road vehicle, please don’t drive on the highway!
Do not overload while driving, so as to avoid potential safety
hazards like reduced brake performance.
Unqualified perso
nnel are not allowed to drive the vehicle.
Please drive within the approved slope range.
To Next Page
Loading...
General