Electro
nic
control
gear
motor
14. Check whether there is water entering
and check the heating condition.
√
15.Motor carbon brush (wear).
√
16. Whether the accelerator pedal is flexible
and reliable and reset.
√
17. Wear of brake drum and friction plate,
and adjustment of hand brake.
√
18. Brake hoses and pipes (oil leakage and
damage).
√
19. Brake fluid (liquid level, with or
without leakage).
√
20. Tyres and clamp nuts (tread wear, air
pressure, tightness of nuts).
√
21. Shock absorber (oil leakage, inelasticity
and abnormal noise).
√
22. Drive shaft bolts (fastening).
√
23. Change the oil of the rear axle gear.
Change the oil of a new vehicle
once a month or per 1000
kilometers, change the oil for the
second time after two months,
and then change the oil every six
24. Add lubricating oil to steering gear box
and hub bearings.
√
25. Front and rear suspension (tightness,
abnormal noise, rupture) and toe-in
√
26. Clean the surfaces of vehicle body, seat,
motor and controller.
√
27. Road test.
Road test must be carried out
after each maintenance operation
to observe the condition of each
13. Fuse location:
Plug-in accessory fuses (six fuses for DC system and six fuses for AC
system) are installed centrally in the fuse box which is inside the instrument
desk.
One bayonet main fuse is installed on the controller mounting plate under
the rear seat.
To Next Page
Loading...
General