Venstar ColorTouch - Page 9

7
MAKING 5 WIRES WORK when 6 are required
(without the optional Add-A-Wire accessory)
• If you have an all-electric heat system with air conditioning, this
method is not an option. You must either pull new wire or use the
optional Add-A-Wire accessory (ACC-0410).
• If you have a multi stage system that requires 6 wires, and you
would like install the Venstar ColorTouch using only 5 wires, follow
the directions below. You will need a screwdriver along with a 3” or
4” long piece of thermostat wire to use as a jumper.
1. Makesurethepowerisoasstep1onpage6instructsyou.
2. Followstep4onpage9“LabelandDisconnectWires”atthe
thermostat.Pleasenotethecolorandthecorrespondingwire
designatorwitheachcolor.AnexampleistheRwireisredandthe
Wwireiswhiteandsoon.Youwillneedthisforthenextstepat
theHVACequipment.
3. Attheequipmentendofthethermostatwires,locatethe
terminals that the wires are attached to.
 A. Removethe“Gwire”fromtheterminalmarkedG.
 B. Placethe“Gwire”onterminalC.
 C. PlaceoneendofthejumperonterminalG.
 D. PlacetheotherendofthejumperonterminalY.
  Pleasenotethattherewillbemorethan1wireonterminalY.
E. ConnectthewirestotheterminalsontheColorTouch
backplate taking care to make sure that each wire from the
HVACequipmentisconnectedtothesameterminalonthe
ColorTouchbackplate.Forexample:the“Cwire”fromthe
HVACequipmentisconnectedtothe“C”terminalofthe
thermostat and so on.