To Next PageTo Next Page
Need help?Do you have a question about the Vent-Axia ACM100 B and is the answer not in the manual?
Adherence to I.E.E. regulations and national standards for wiring.
Requirement for a local double pole isolator switch with at least 3mm contact separation.
Ensure mains supply (Voltage, Frequency, Phase) matches the rating label.
Use only with appropriate Vent-Axia products.
Recommended connection to fan terminals using flexible cable.
Precautions for rooms with fuel-burning appliances to avoid gas back-flow.
Avoid direct water spray for prolonged periods.
Positioning, ducting, and ensuring access for maintenance.
Steps to release and slide out the motor impeller assembly.
Securing the fan and re-inserting the motor impeller assembly.
Isolate power, double insulation, no earthing required.
Steps for connecting the fan, checking connections, and ensuring secure fastening.
How to adjust the fan's overrun timer from 3-25 minutes.
Adjusting fan speed via jumper settings (Low, Medium, High).
Using a speed controller with basic versions; not with timer models.
Built-in thermal overload protection automatically switches off the fan.
Regular inspection, cleaning, and note on sealed bearings.
General| Type | Centrifugal |
|---|---|
| Airflow | 220 m³/h |
| Noise Level | 41 dB(A) |
| Power Consumption | 25W |
| Power | 25W |
| Voltage | 230V |
| Dimensions | 245mm x 196mm x 184mm |
| IP Rating | IP44 |
| Frequency | 50Hz |
