4ENVenta LW60T
1 Display
2 On/o switch
3 Evaporator compartment
4 Water tank
5 Disc stack
6 Water basin
7 Fragrance compartment
8 Fragrance holder
9 Cable compartment
10 Hygiene Disc (pre-assembled)
11 Remote Control
12 Transportation wheels
01 08
PUTTING INTO OPERATION
OVERVIEW
01 Unpack the appliance and set it up.
02 Open the evaporator compartment 3 and remove the water tank 4.
03 Open the water tank 4 and ll up to the MAX marker with water.
04 Close the water tank 4 securely.
05 Insert the water tank 4 into the water basin 6 and close the evaporator
compartment 3.
06 Inserting the fragrance: Open the fragrance compartment 7. Twist open
the fragrance cap and insert it into the fragrance holder 8. Insert up to
three fragrances into the fragrance holder 8. Close the fragrance compart-
ment 7.
07 The display 1 can be adjusted to three positions.
08 The power cable can be adjusted to the desired length by winding it up in
the cable compartment 9.
Move the appliance with the transportation wheels 12 to the desired place.
Lift the appliance slightly on the right sight.
Attention! Make sure that the appliance is switched o and the
power plug is disconnected.
ATTENTION! The coupling of the mains cable must be plugged rmly into the
device! Please remove the protective foil for battery and remote control.
Connect the power plug and switch on the appliance
at the on/o switch 2 or with the remote control 11.
ATTENTION! It may take about a minute for the device to
start and for the “Fill Tank” indicator in red or yellow to be extinguished. A gurg-
ling sound may be heard, but this does not represent a quality defect.
Set fan stage
ON/OFF
To Next Page
Loading...
