SAFETY
B-3
Ventrac 4100 Safety Procedures
Before Operating
•
Check engine fluid levels before starting.
•
Check brake action before operating and adjust or service as needed.
•
Inspect machine before operating. Be sure shields and guards are in good condition
and securely in place. Be sure hardware is tight and repair or replace parts that are
missing, badly worn or damaged. Check that wheel nuts are tight after first 15-20
hours of operation, and after each time a wheel is removed.
Safe Transport
•
When driving on public roads, use a Slow Moving Vehicle sign. Additional flashing
warning lights should be installed. Check local traffic laws.
•
Be careful around traffic when crossing roadways or operating near them.
•
Operate only during daylight or with good artificial light.
Use Extra Care
•
Stay alert for holes, hidden objects, and uneven terrain.
•
Use extra care when you come to shrubs, trees, or other objects that may block your
vision.
•
Clear from work area objects that may be thrown.
•
If you hit an object, stop machine and check for damage.
•
Avoid adverse ground conditions which can limit performance and stability of
equipment and could result in serious injury or death.
•
Stay away from drop-offs.
•
DO NOT drive where machine could slide or upset.
•
Wet grass increases risk of sliding on banks and slopes.
•
DO NOT try to stabilize the tractor by putting your foot on the ground.
•
When pulling loads or using attachments, use only the hitch points provided. Limit
loads to those you can safely control.
Before making any repairs or adjustments, lower
attachment to the ground, set parking brake, shut
the engine off, and remove the key.
Read and understand the operator’s manual before
operating this equipment.
To Next Page
Loading...
