Need help?Do you have a question about the Ventum NS1 and is the answer not in the manual?
General| Category | Road Bike |
|---|---|
| Frame | Carbon |
| Fork | Carbon |
| Drivetrain | Shimano 105 |
| Brakes | Hydraulic Disc |
| Tires | 700x25c |
| Handlebar | Aluminum |
| Stem | Aluminum |
| Seatpost | Carbon |
Instructions for removing the main parts box and support cover.
Instructions for removing top tube foam and shifter blocks.
Instructions for removing straps and foam blocks from the wheels.
Instructions for removing wheels from the box and removing hub guards.
Steps to detach the seat post and remove protective foam.
Instruction to undo the strap around the bottom bracket.
Steps to connect Di2 cable and insert seat post into frame.
Instruction to torque the seat post clamp bolt to specified N.m.
Instructions for removing straps from the handlebar.
Steps to lift the frame out of the box and detach crank arm strap/foam.
Instructions to unscrew thru axles using a 6mm hex tool.
Instructions for removing spacers from the brake calipers.
Instructions to install wheels, aligning rotors between brake pads.
Instructions to secure wheels by re-installing thru axles and torquing.
Instructions for installing pedals and checking tire pressure.
Instructions for adjusting saddle height and wearing helmet/shoes.
Instructions to check operation of brakes, derailleurs, and steering.
To Next Page
