Ventum NS1 - Final Checks and Road Test; Pedal Installation and Tire Pressure; Saddle Height and Safety Gear; Brake and Drivetrain Operation Check

22
1. Install your pedals as per the manufacturer’s instructions.
2. Check the tire pressure and inflate as per the manufacturer’s
recommendation.
3. Adjust the saddle height as necessary. Ensure the seat post minimum
insertion depth of 10 cm is achieved.
4. Put on your shoes and helmet and take your new bike out for a road
test. Always wear a helmet when you ride your bicycle.
5. Check the operation of the brakes, derailleurs, and steering.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD LEAD TO SERIOUS INJURY OR DEATH.
FINAL CHECKS & ROAD TEST