Ventum One User Manual

ONE DISC USER MANUAL
Ventum One Disc Torque Specs
▼ Seatpost clamp: 6-8 Nm
▼ 2 nose-cone side bolts: hand tight
▼ Mono-riser bolts (behind the nose cone): 7 Nm
▼ Mast tilt bolts (between arm pads): 7 Nm
▼ Base bar bolts: 7 Nm
▼ Aero-extension holder bolts: 5 Nm
▼ Arm cup/pad bolts: 3 Nm
▼ Stem bolts: 6-8 Nm
▼ TRP brake lever bolts (on base bar): 3 Nm

Ventum One Specifications

General

Brand	Ventum
Model	One
Category	Bicycle
Language	English

Summary

Seatpost Clamp Setup

Seatpost Clamp Installation and Adjustment

Steps for inserting, torquing, removing, and adjusting the seatpost clamp for optimal fit and security.

Nose-Cone Side Bolt Installation

Nose Cone Side Bolt Tightening

Instructions for positioning and hand-tightening the nose cone side bolts.

Mono-Riser Bolt Installation

Mono-Riser Bolt Tightening

Guidance on positioning the mast clamp and torquing mono-riser bolts.

Mast Tilt Bolt Installation

Mast Tilt Bolt Tightening

Stem Bolt Installation

Stem Bolt Torque

Mast Adjustments

Mast Tilt Adjustment

Mast Height Adjustment

Front End Assembly

Cable and Hose Routing

Recommended paths for routing brake hoses and Di2/Etap cables through the front end assembly.