To Next Page

To Previous Page

- E10 -

PRESET TUNING

1. Press the FUNCTION button

to TUNER.

2. Press the BAND button to

select the a band.

3. Press the PRESET buttons

to preset number.

TUNING INTO A PRESET STATION

1. Press the FUNCTION button

to TUNER.

2. Press the BAND button to

select a band .

3. Tune into a station.

4. Press the MEMORY/

CLOCK button.

5. Use the UP/DOWN buttons

to select the pre-set number.

6. Press the MEMORY/

CLOCK button to store the

station to the pre-set number.

The contents (preset channel number, frequency and frequency band) which have been stored

in memory will appear on the display in numerical order, irrespective of the frequency bands.

FOR BETTER RECEPTION

Fully unwind the wire antenna. Then extend the

wire antenna and place it in the position that

sounds best.

NOTE: Do not connect to outside antenna.

Connect the loop aerial (provided) to the

'AM LOOP ANTENNA' snap terminals at the

back of the unit. Position the aerial for the

best reception.

2088_eng2.PMD 10/29/2004, 2:55 PM10

Venturer CD2088 User Manual

Questions and Answers: