7
3. Reattach the latch.
4. You are highly recommended to connect the AC/DC adaptor. For the feature of
the automatic backlight control function, the AC/DC adaptor must be used.
5. If placing the console unit on a table or horizontal surface, set up the table
stand and you can put it on table.
6. If mounting the console unit on a wall or vertical surface, remove the table
stand and use the fitting provided.
Placement tips:
Make sure that the console unit is within receiving range of all remote sensors.
Ideally sensors should be within the line of sight of the console unit. Transmission
range may be affected by trees, metal structures and electronic appliances. Test
reception before permanently mounting your weather station.
The console unit measures indoor temperature, humidity, pressure and receives
signals from all remote sensors and radio-clock broadcasts. Avoid placing the
console unit in the following areas:
- Direct sunlight and surfaces which radiate and emit heat.
- Near heating and ventilation devices, such as heating ducts or air conditioners.
- Areas with interference from wireless devices (such as cordless phones, radio
headsets, baby listening devices) and electronic appliances.
Starting up the Main Console Unit
Once the console unit is properly powered, the display will start showing some
data and weather parameters. Wait for a few minutes for the console to finish
self-calibration and for the sensor readings to show up.
If “---” is still displayed for the sensor reading(s), check the wireless transmission
path and the batteries for the corresponding sensor.
To Next Page
Loading...
