Advanced Z-Wave Functions
Basic Command Class Handling
The basic command class is controlled by Vera and it is not mapped
to any other Z-Wave Command Class.
More details can be found on our wiki page.
http://wiki.mios.com/index.php/ZWave_Basic_Command_Class_Mapping
Support for Association Command Class
VeraSecure has support for the Lifeline association command class.
group id: 1 - lifeline
number of nodes in group: 1
More details can be found on our wiki page.
http://wiki.mios.com/index.php/Association
Support for Multiple Manufacturers in The Same Network
The controller can be included and operated in any Z-Wave network with
other certied Z-Wave devices from other manufacturers and/or other
applications. All non-battery operated nodes within the network will act
as repeaters regardless of the vendor to increase the reliability
of the network.
Support for sending Z-Wave Commands
Z-Wave commands can be sent using the Vera API which will allow you
to send HTTP requests with the specied command class to the specied
node.
More details can be found on our wiki page.
http://wiki.mios.com/index.php/Luup_UPnP_Variables_and_Actions#
ZWaveNetwork1
To send a Z-Wave command you’ll need to add the node id of the con-
trolled Z-Wave device and the command class used.
For example to control node 3 and send a BASIC_SET with a value
of 00, the command will be :
http://GATEWAY_IP/port_3480/data_request?id=
action&DeviceNum=1&serviceId=urn:
micasaverde-com:serviceId:ZWaveNetwork1&action=
SendData&Node=3&Data=0x20-0x01-0x00
GATEWAY_IP is the actual local IP address of the unit.
Node is the Z-Wave node the command is sent to.
Data will contain the Z-Wave Command Class sent to the device.
To Next Page
Loading...