16
0900‑5209 REV‑00
Procedure 1. Prepare the GlideScope System
*
Note: The inside diameter of the suction tubing should be between 6.0 and 7.0 mm, inclusively.
Note: If the monitor locks up, becomes unresponsive for any reason, or does not show an image from
the bronchoscope, consult the monitor's Operations & Maintenance Manual for resetting instructions.
Note: The time required for the anti‑fog feature to be fully optimized varies according to the ambient
temperature and humidity where the equipment is being stored or used. If the bronchoscope is stored in
cold conditions, additional warming time may be required for optimal performance of the anti‑fog feature.
To Next Page
Loading...
