Merchant services are provided by Paymentech, LLC (“Chase”), a subsidiary of JPMorgan Chase Bank, N.A.
©2020 JPMorgan Chase & Co
Verifone P400
Setting up and
connecting your card
reader requires just a
few steps.
You should have already unpacked your card reader and activated your reader in the Chase
Merchant Center. If not, visit chase.com/MyPaymentsCenter to complete your activation.
Important
: Your card reader should remain unplugged and powered off until you’ve
completed activating your device in the Chase Merchant Center.
2.
Connect the dongle cable to the back of the card reader and the power supply to the
dongle cable and power source. See diagram below.
Note: The card reader will turn on automatically once it is plugged into a power source.
To Next Page
