Veripart VRIEZER - Precautions for Use; Setting the Temperature; Use

33
EN
4. USE
4.1 PRECAUTIONS FOR USE
• On rst use or after a long period of downtime: run the appliance for at least four hours at position ‘MAX’
before placing products in the freezer. After 24 hours, set the temperature control between ‘MIN’ and ‘MAX’.
• The appliance may not operate optimally (risk of thawing or too high a temperature in the freezer) if it is in a
place where the ambient temperature is below the minimum of the temperature range for which the appliance
is designed for a longer period of time. The information about the temperature range (climate type) of the
appliance is stated on the type plate, which is explained in section 1.3.
• The interior temperature may be affected by factors such as the location of the cooling unit, the ambient
temperature and the frequency with which the door is opened. Adjust the temperature setting if desired.
• If vibration noise occurs because the appliance is positioned against the wall or if the wall becomes black due
to air circulation around the compressor, you should place the appliance away from the wall.
• Do not place lled glass or can packages in the freezer to avoid breakage due to volume expansion.
• Do not place electrical appliances in the freezer (such as ice cream machines) unless they are of a type
expressly declared suitable by the manufacturer.
• Packaging with ammable gases or liquids may leak at low temperatures, do not store ammable gases or
liquids in the appliance.
• Do not store containers containing ammable materials, propellant or explosive substances such as aerosols,
rell cartridges for re extinguishers, etc. in the appliance.
• Do not place carbonated or sparkling drinks in the freezer compartment.
• Do not use the appliance if any of its components are damaged or faulty. Replace a damaged or faulty
appliance immediately. Remove the plug from the earthed socket and contact customer service.
• Only use the power cable installed on the appliance from the factory. Do not change the power cable. The
power cable may only be replaced by an authorised service technician.
• Never use the appliance in a damp room, such as a bathroom, or in the vicinity of a bath, shower or swimming
pool.
• Before use, check that the voltage on the socket you want to use matches that on the type plate of the appliance
(220-240V~ 50Hz). Only connect the appliance to an earthed power socket. Damage caused by faulty voltage
is not covered by the guarantee.
THERMOSTAT
SETTING
MINIMALE
TEMPERATUUR
MAXIMALE
TEMPERATUUR
SETTING
Position 1 3°C 10°C
Refrigerator setting, not suitable for freezing
products.
Position 5
-1°C 4°C
Refrigerator setting, not suitable for freezing
products.
‘MIN’ position
-15°C -
Freezer
‘MAX’ position
-24°C - Freezer
4.2 SETTING THE TEMPERATURE
The freezer can be used as a refrigerator. To do so, set the thermostat to
position 1. The temperature setting of position 1 is between 3°C and 10°C,
depending on the ambient temperature.
The recommended freezer temperature is -18°C. To do so, set the thermostat
between ‘MIN’ and ‘MAX’.
The internal temperature of the appliance may vary depending on the
ambient temperature, the amount of products stored and the frequency with
which the door is opened. It is advisable to keep the time between buying
the food and putting it in the freezer as short as possible.