Verkada CD52 - Whats in the Box; Required Tools and Connections; Camera Connection and Registration

Introduction
What’s in the box
What you’ll need
● A working Internet connection.
● 802.3af Power over Ethernet (PoE) switch,
or a PoE injector. For operation below
-20° C, use 802.3at PoE.
● A smartphone or laptop
● A #2 Phillips screwdriver or power drill
with a #2 Phillips driver bit
● 1/4 inch (6.5mm) drill bit for wall anchors
● 1/8 inch (3mm) drill bit for pilot holes
● A Cat5 or Cat6 Ethernet cable with a
0.2-0.25 inch outside diameter
(5-6.5mm)
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
sales@verkada.com
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
CD52 Outdoor Camera Mount plate
(Attached to camera)
Mounting template
2 Pole straps Cable gland wrench T10 Security Torx screwdriver
Connect
For easy registration and setup, scan the QR
code on the product.
If you prefer to manually register your product,
please proceed to:
If you prefer to manually register your product,
verkada.com/start
If you prefer to manually register your product,
4 Wall anchors4 M4 x 25mm PH2
wall screws
Conduit adapter
(with 2 screws and anchors)
Desiccant
3