Installation
Cable Gland Assembly 1/2
To seal the Ethernet cable,
disassemble the cable gland and
feed the Ethernet cable through
the baseplate through-hole.
1. Place the rubber seal around the
cable. Push the plastic collar firmly
over the rubber seal until it snaps
into position.
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
sales@verkada.com
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
2. Firmly insert the seal and collar
assembly into the pass-through
until it is secured in position.
5
To Next Page
Loading...
