Grinder, stump - Vermeer Manufacturing Co. - SC252
Operating Information
Before you start
Dig away the earth and remove any stones near the tree stump that may
interfere with your work. Check that the ground is free of foreign objects, such
as electrical cables, barbed wire, etc. Cut or trim the stump as necessary using
a power saw.
Review all of the machine’s safety decals.
Use a hard hat, ear and eye protection. A mesh visor alone does not
provide sufficient eye protection; supplement with protective glasses.
Make sure that you are familiar with safety regulations and shutdown
procedures.
Make sure that all guards are in place and in good condition.
Make sure that the blades and cutters are in place and in good condition.
Make sure that the work area and cutter in particular and free from metallic
objects such as wire, nails, etc. that could be thrown out and injure persons in the vicinity and damage the equipment.
Make sure that everyone, including children and animals, maintains a
distance of at least 50 feet (15 M) from the machine. Debris can be thrown
out and injure people and animals.
Using your stump grinder
NEVER allow the blade to touch the ground until it has
stopped turning.
To Next Page
Need help?
General
