©2015 Green Manufacturing, Inc. 10
Target Organs: May affect the respiratory system.
Carcinogenicity: NTP: No IARC: No OSHA: No
EMERGENCY AND FIRST AID PROCEDURES:
INHALATION: Remove victim to fresh air. Keep warm and quiet, give oxygen if breathing is difficult and seek
medical attention.
INGESTION: If conscious, give 1-2 glasses of milk or water and induce vomiting (Never induce vomiting or give
anything by mouth to an unconscious person). Seek medical attention.
SKIN: Remove contaminated clothing from affected area, brush material off skin. Wash affected area with mild
soap and water. Seek medical attention if symptoms persist.
EYE: Flush eyes with lukewarm water, lifting upper and lower eyelids, for at least 15 minutes. Seek medical
attention if symptoms persist.
VI - REACTIVITY DATA
Stability: Stable
Conditions to Avoid: None
Incompatibility (Material to Avoid): Chlorine, fluorine, nitrogen dioxide, nitrous oxide, iodine pentafluoride and
lead oxide.
Hazardous Decomposition Products: None recorded.
Hazardous Polymerization: Will not occur
VII - SPILL OR LEAK PROCEDURES
Steps to Be Taken in Case Material Is Released or Spilled: Wear appropriate respiratory and protective equipment
specified in Section VIII. Isolate spill area and provide ventilation. Vacuum up spill using a high efficiency
particulate absolute (HEPA) air filter and place in a closed container for proper disposal. Take care not to raise
dust.
Waste Disposal Method: Dispose of in accordance with all local, state, and federal regulations.
VIII - SPECIAL PROTECTION INFORMATION
Respiratory Protection: NIOSH approved dust, mist, and vapor cartridge respirator.
Ventilation: Use local exhaust ventilation which is adequate to limit personal exposure to airborne dust levels
which do not exceed the appropriate PEL or TLV. If such equipment is not available, use respiratory protection as
specified above.
Protective Gloves: Rubber gloves.
Eye Protection: Safety glasses.
Other Protective Clothing or Equipment: Protective gear suitable to prevent contamination.
IX - SPECIAL PRECAUTIONS
Precautions to Be Taken in Handling and Storage: Store in a tightly sealed container in a cool, dry, well-ventilated
area. Wash thoroughly after handling.
Other Precautions: Implement engineering and work practice controls to reduce and maintain concentration of
exposure at low levels. Use good housekeeping and sanitation practices. Do not use tobacco or food in work area.
Wash thoroughly before eating or smoking. Do not blow dust off clothing or skin with compressed air.
The above information is believed to be correct, but does not purport to be all inclusive and shall be used only as a
guide. Green Manufacturing, Inc. shall not be held liable for any damage resulting from handling or from contact
with the above product.
To Previous Page
Loading...
Need help?
General
