Need help?Do you have a question about the Vermont Castings Defiant Encore 0028 and is the answer not in the manual?
General| Category | Wood Stove |
|---|---|
| Model | Defiant Encore 0028 |
| Fuel Type | Wood |
| EPA Certified | Yes |
| Burn Time | Up to 10 hours |
Introduces the Defiant Encore stove, highlighting its heritage and technology.
Provides guidance on reading and understanding the manual for effective use.
Lists technical specifications including heat output, dimensions, and fuel capacity.
Explains wood combustion stages and the advanced catalytic system for efficient burning.
Describes primary and secondary air controls for optimizing burn performance.
Explains the design and function of the dual ceramic glass panels for fire viewing.
Advises on fuel selection and operation of damper/thermostat controls for heat regulation.
Guides on starting fires, closing doors, and initial operation.
Guides users through initial fire-setting to condition the cast iron stove.
Outlines steps for starting and managing daily fires for efficient heating.
Details the four stages of combustion from initial fire to charcoal phase.
Covers safe reloading, ash removal, disposal, and open fire mode.
Covers cleaning surfaces, checking air shutter, and adjusting door latches for optimal function.
Provides instructions for cleaning and replacing the stove's ceramic glass panels.
Introduces the catalytic combustor and its importance for efficient operation.
Details how to inspect the catalytic element for damage, blockage, or wear.
Explains the importance of gaskets and how to inspect and replace them.
Illustrates various gasket locations and types used for sealing stove components.
Discusses codes, UL standards, and the role of chimneys and draft in installation.
Details requirements for new chimneys and inspection of existing ones.
Addresses outside air supply and how draft affects stove performance.
Defines clearance, its importance, and how to use clearance charts for safe installation.
Presents a chart and explains how heat shields reduce required clearances.
Details wall shield requirements and guidelines for passing connectors through walls.
Covers fireplace mantel shielding and chimney connector material/length requirements.
Outlines floor protector needs for freestanding, fireplace, and special installations.
Details specifications for shields used with fireplace mantels and trim.
Covers chimney connector material, length, turns, and slope requirements.
Lists pre-installation checks, permits, and guides on stove setup.
Provides step-by-step instructions for assembling the chimney connector sections.
Details methods for connecting to both prefabricated and masonry chimney systems.
Describes connecting the connector above or through fireplace openings to the flue.
Verifies clearances, protection, and chimney connections for safe installation.
Provides tips on safe operation, preventing overfiring, draft issues, and safety equipment.
Explains technical terms used in the manual, such as flue, chimney, and clearance.
Defines terms related to combustion processes and materials like creosote and volatiles.
Explains the role, benefits, and potential issues of the catalytic combustor.
Details warranty terms, coverage, exclusions, and limitations for the stove and parts.
Provides a visual diagram of stove components with part numbers for identification.
To Next Page
