PAGE 17
5. BATTERY CHARGING AND CARE
5.1 CHARGING THE BATTERY
Follow the procedure below step by step:
1. Turn the power switch to (OFF)
2. Connect the charger’s power cord into the
power outlet.
3. Open the charging socket cap on the battery
pack. Then connect the charger’s round plug
to the charging socket.
4. Turn on the switch on the charger.
5. The charger’s LED will be lit green when
the power is on, and will turn red when
charging. The charging duration is about 6
hours. To ensure optimum performance a
10-hour charge is recommended. But we do
not recommend a charging more than 24
consecutive hours.
6. The charger’s LED will be lit RED during the
charging process. The LED will turn green
when charging is completed.
7. Turn o the charger; disconnect the power
cord and the round plug from charger socket
on the scooter.
Warning!
» The fan inside the charger will be activated accordingly when you turn on
the charger. If the fan does not work when connected to the charger or
the green light is not showing, DO NOT use this charger. It may lead to
overheating of the charger and cause a re as a result.
» There is a red LED present on the charger to illustrate operation. If this LED
does not illuminate the charger is defective, please contact your dealer.
To Next Page
Loading...
General