PAGE 20
5. BATTERY CHARGING AND CARE
Cleaning the battery
If the batteries are contaminated by water, battery acid, dust or other substances, they
will discharge quickly. The batteries supplied with the I-GO scooter are sealed and as
such are maintenance free with no risk of battery leakage. Please follow the steps below
to clean the battery.
1. Turn the scooter power switch to “OFF”.
2. Remove the seat and dust cover.
3. Remove the shroud and unplug the terminal of the tail light and signal lights.
4. Use a clean cloth to wipe o the soiled area.
5. Take out the battery.
6. Clean the battery with a clean cloth. If the terminal is covered by white powder,
please wipe it clean using warm water.
Warning!
1. The wiring system and charger are well situated in battery pack while
assembled in plant. Do not attempt to re-locate the wiring system by
yourself. The improper layout of wiring system may result in the wires
getting pinched by battery box, which might cause electronic system
failure.
2. Be sure the battery wires are connected to the right battery terminal.
Suggestion
If necessary, ask for help from your dealer for advice about maintaining and
replacing the battery.
Suggestion
1. Make sure the terminals are installed properly and put the covers back on.
2. Do not use the battery to charge telecom equipment or other items.
3. Battery eciency will vary with outside conditions; the driving distances
will be shorter in the winter. If the vehicle is not used for a long time,
please charge the battery at least every week.
4. Replace both batteries together.
To Next Page
Loading...