PWC – 450
PureWaterCooler
Copyright 2011 Vertex Water Products
2. Cooler Set-Up cont.
2.4 With both hot and cold power switches in the off
position, plug the cooler into power.
2.5 Press and hold the cold dispense button on the
control panel until water begins to flow from the
spigot. This may take a few minutes depending on
the inlet water pressure. Once the cold tank is full,
repeat this process for the hot tank by pressing the
hot lock button and then holding the hot dispense
button.
2.6 Once both hot and cold buttons dispense water, turn
the hot and cold switches on the back of the cooler
to the on position. Hot water will be ready quickly,
but cold water may take a few hours.
2.7 The cooler is ready for use.
To Next Page
Loading...
Need help?
General
