5.2. Pulse Detection System
A. Hand Grip Sensor System
Put hands on the steel sensor of the front handrail to detect the pulse system during
workout. Each handrail is equipped with two sensors. You must grip these four sensors to
catch the pulse signal during workout. After 20 to 30 seconds, the result will display.
When the speed is above 4.5mph (7.2KPH), you shouldn’t grip the sensor for stability but
to use chest belt pulse monitor.
B. Chest Belt Pulse Monitor
Pulse detection system includes chest belt pulse monitor which should be put electrode on
the body. Remote sensor technology is used to transmit the pulse signals to control board.
Chest belt is not the necessary attachment. You can purchase if you need
Figure: middle electrode position and wearing ways of chest belt
To Next Page
Loading...
General