LIEBERT PSI5™ UPS
Quick Installation User Guide
590-2192-617A/SL-70358_REV0 1
I M P O RTAN T: Before installing,
connecting to supply or operating
your Liebert PSI5
TM
UPS, please
review the Safety and Regulatory
Statements sheet. For detailed
installation, operating, maintenance
and troubleshooting information
refer to the PSI5
TM
User Guide
available at www.VertivCo.com.
INSTALLATION
1. Inspecting the UPS
Inspect the UPS for any signs of
obvious damage. If damage is
visible, do not proceed and call
our warranty support line for
assistance at 1-800-222-5877
menu option 3, or email at
microups.warranty@vertivco.com.
2. Choosing a location
Install the UPS in a
temperature-controlled
environment that is free of
corrosive and conductive
contaminants. Avoid locations
near heat or water sources and
exposed to direct sunlight. For
proper ventilation, leave four
inches clearance on all sides of
the UPS.
The input outlet should be
nearby and easily accessible.
3. Installing the UPS
The UPS and optional PSI5
TM
UPS External Battery Cabinets
may be installed in either a
tower or rack configuration. For
tower installation, assemble and
attach the tower support stands.
For rack installation, attach the
brackets to the UPS, install the
rail kit in the rack if needed, and
install the UPS in the rack.
NOTE:
This UPS is not for use in a
computer room as defined in the
standard for the protection of
electronic computer/data
processing equipment of ANSI/
NFPA 75.
# Description
1 Grounding screw
2 Network/Fax/Modem surge protection input/output
3 External battery connector
4 USB communication port
5 Programmable receptacles
6 Non-programmable receptacles
7 SNMP IntelliSlot port
8 Emergency Power O (EPO) connector
9 Input circuit breaker
10 AC input
11 Output circuit breaker
PSI5-3000RT100
PSI5-1500RT100
MODEL DESIGN CONFIGURATIONS
To Next Page
Need help?
General