English - 53 -
Menu Features and Functions
Picture Menu Contents
Press to view 3D settings.
Mode
For your viewing requirements, you can set the related mode option. Picture mode can
be set to one of these options: Cinema, Game, Sport, Dynamic and Natural.
Sets the lightness and darkness values of the screen.
Sets the brightness value for the screen.
Sets the sharpness value for the objects displayed on the screen.
Sets the colour value, adjusting the colors.
Power Save
Mode
To set Power Save Mode as Eco, Picture Off and Disabled. See the section, “Environmental
Information” in this manual for further information on Power Save Mode.
If Picture Off is
selected, “Screen will be off in 15 seconds” message will be displayed on the screen.
Select PROCEED and press OK to continue. The screen will be off in 15 seconds. If you
disable Power Save Mode, Picture mode will be automatically set to Dynamic.
Backlight
(optional)
This setting controls the backlight level and it can be set to Auto, Maximum, Minimum and
Eco Mode. Backlight function will be inactive if Power Save Mode is set to On. Backlight cannot
be activated in VGA, Media Browser mode or while the picture mode is set to Game.
If the broadcast signal is weak and the picture is noisy, use Noise Reduction setting to reduce the
noise amount. Noise Reduction can be set to one of these options: Low, Medium, High or Off.
Pixellence
Demo Mode
While Mode option is highlighted in picture menu, Pixellence demo mode will be displayed
bottom of the menu screen. Pixellence function optimizes the TV’s video settings and helps
to acquire a better image quality. Pixellence mode thus includescontrast, sharpness, colour
enhancement and skin tone correction along with the skin tone detection.Press OK to start
Pixellence demo mode for experiencing Pixellence quality. Throughout the demo mode,
the screen is splitted into two sections, one displaying the Pixellence active area; the other
displaying the normal broadcast. Press OK button to quit the demo mode.
Not: Pixellence demo mode will not be available in 3D mode.
Advanced Settings
You can change contrast rate by using dynamic contrast function. Dynamic contrast can
be set to one of these options: Low, Medium, High or Off.
Sets the desired colour tone.
Picture Zoom
Sets the picture size to Auto(Only available in Scart mode with SCART PIN8 high voltage/low
voltage switching),16:9, Subtitle,14:9, 14:9 Zoom, 4:3 or Cinema.
While watching from HDMI source, this feature will be visible in the Picture Settings
menu. You can use this feature to enhance blackness in the picture.
Film Mode
Films are recorded at a different number of frames per second to normal television programmes.
Turn this feature on when you are watching lms to see the fast motion scenes clearly.
Adjust the desired skin tone.
Adjust the desired colour tone.
RGB Gain
Press OK button to edit RGB gain. You can congure the colour temperature values
using the RGB Gain feature.
Resets the picture settings to factory default settings.
Autoposition
Automatically optimizes the display. Press OK to optimize.
To Next Page
Loading...
Need help?
General
