20. Do not place the product directly on the fire or near the source of the
fire. Otherwise, the product will be damaged or even result in danger.
21. When the plug is plugged into the socket, it must be plugged into the
end. Otherwise, it will cause the components to overheat and burn due to
poor contact.
22. Do not leave the product to work with no one watching. If the machine
is overheating, please stop working immediately and unplug the power.
23. Once part of the product is on fire, do not directly use water to
extinguish the fire. Use a wet cloth to cover the fire site.
24. Please store the plastic bags and not allow children to play with them
to prevent a risk of suffocation.
25. It is prohibited to put the main body of the machine and the power cord
into any liquid.
26. DO NOT open the case door; the hands are strictly forbidden from
touching the saw blade while the machine operates.
SAVE THESE INSTRUCTIONS
1. Move the guide block to the correct height according to the size, then fix
it.
2. Adjust the thickness adjustment plate according to the required meat
size.
3. Press the green button on the power switch. Do not push the sawed
item too much during the operation. This will cause the saw bar to fall off
or be damaged.
4. The operator should stand before the machine and push the product
horizontally and straight.
5. The serrate should be exposed outside the wheel when replacing the
saw blade.
6. The side of the saw blade presses the looseness of the saw blade with
the force of rebound.
7. Turn the upper wheel with your hand. Run the saw blade in and adjust
To Next Page
Loading...
