the screw counterclockwise. Run the saw blade out and change the screw
clockwise.
The machine must be cleaned up after completion because the meat
residue and foam attached to the body will not be hygienic for a long time.
The next time you use it, the noise increases, and the saw blade is easily
damaged.
Diagnosis and repair of faults
1. Chainsaw often breaks
Reason: a. The band saw is of poor quality b. The band saw is too tight c.
Overpush or improper use, It is not direct push.
Repair: a. Use a good band saw. b. Adjust the band saw properly and
adjust the handle make sure the band saw is not too tight. This is because
the side of the saw blade presses the looseness of the saw blade with the
force of rebound.
2. Departure with band saw
Reason: a. band saw is too loose. b something attached to the pulley. c.
Improper use Repair: a. Adjust the handle of the band saw properly so that
it does not loosen too easily. b. Remove the thing attached to the pulley. c.
Use correctly.
3. Other malfunctions
Consult the agent, and please do not repair it by yourself. During the
warranty period, the company is not responsible for the warranty of motor
losses caused by improper operation, such as(water intake, lack of phase)
To Next Page
Loading...
