Time Setting
In standby mode, press the "AUTO" and "WASH" buttons for 5 seconds,
the window shows "F1 01", then you can click the “UP” or “DOWN” key to
adjust the back number. Press “ ” key, the window shows “F2 12”, by
such analogy until " F7 30".
Note: F1 says mark symbol, 01、02、03……30says actual value.
F1 -- week (00 - Sunday) F2 -- year F3 – month F4 -- date
F5 -- hours F6 -- minutes F7 -- seconds
◆WASH KEY
Press wash key “ ”, the “CLEAR” icon light and the beater starts to work.
It will be closed when you press it again.
◆STANDBY KEY
Press “ ”, “STANDBY” key are on, the display hardness percentage
display window shows the cylinder temperature, the display “SET” display
window shows the temperature of the hopper.
◆AUTO KEY
Press standby key ， “AUTO”and“FRESH”icon will light. The little
compressor for hopper is controlled by setting temperature. It will stop
when the temperature is less than the setting value, and it will start again if
the tempreature in hopper raise for 2℃. The big compressor for cylinder
will stops when the hardness value reach 99，after 15 seconds the beater
motor stops. The beater motor will starts again when the time goes for
setting value(cycle time to restart for machine). After 3 seconds the big
compressor starts.
◆PROTECTION FUNCTION
•The sensor for freezing cylinder is open circuit or short cirult, hardness
window on the screen will show“RL”or“RH”, the buzzer will screams and
the machine stop.
•The sensor for mix hopper is open circuit or short cirult, hardness window
To Next Page
Loading...
