b、Connect the power wire and the power supply, ensuring the yellow and
green wire was connected with the ground wire firmly.
Caution: a.For safety, ensure the ground connection is in
good condition.
b.All the exterior wires and other appliances must confirm
with national standard.
C、Testing Running
1) Switch “ON”the power switch and you will hear “Beep”,all the graphic
patterns on the screen will be lighted up and then the graphic patterns will
extinguish,machine enters “Standby” mode.
2) Press “Wash”, the corresponding indicator will be lighted up and at the
same time you will hear the sound of beater system working.Press the “Wash”
button again,beater system will stop.
3)Press “Auto”,the corresponding indicator will be lighted up and the beater
system will start working. After 3 seconds,the cooling system will also start
working, air pumps in both hoppers enter normal working state.
D、Clearing & Sterilizing
Step 1: Prepare 5-6 liters of warm water, mix with food detergent according to
manufacture’s specifications. And this is the sterilizing solution.
Step 2: Pour the solution into the hopper While the solution is flowing into the
freezing cylinder, brush and clean the mix hopper.
Step 3: Press the key of “clean”, and let the machine running for about 5
minutes.
Step 4: Place an empty pail beneath the draw spout and push down the draw
handle. Draw off all solution.
Step 5: Repeat this operation for 2-3 times with water only.
To Next Page
Loading...
